Echo Audio Mona Manual download pdf (Page 18)

Using SONAR

Here are the required settings for using SONAR with our driver:

Note:

The settings below will need to be reset every time you reconfigure your wave devices.

Go to Options/Audio.

• On the “General” tab, set “Audio Driver Bit Depth” to 24.

• On the “Advanced” tab, we suggest selecting “Trigger & Freewheel”

• On the “Driver Profiles” tab, uncheck “Access Driver In Mono”. Be sure to set

“Stream > 16 bit data as” to “32 bit PCM, left justified”.

You may get a message that your audio devices are not compatible with the specified format; you

may need to restart SONAR several times. Make sure each time that the settings are correct;

once SONAR starts successfully without the “not compatible” message, be sure to run the Wave

Profiler under Options/Audio/General.

To get the smallest possible latency, you should only enable input and output drivers that you

actually intend to use.

We recommend that you try using Super Channel mode in combination with SONAR; using Super

Channel mode can make SONAR more efficient.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

No comments

Echo Audio Mona Manual Page 18