Echo Audio MiaMIDI Owner's Manual download pdf (Page 39)

WDM console – all products

Adjusting Playback Volume

Output volume adjustments are made in the digital domain. When you lower a

volume fader below 0dB, you are actually decreasing the number of available bits,

thereby taking away from the potential dynamic range of the system. Therefore,

we suggest that whenever possible you leave the output faders set to 0dB, and

perform any necessary attenuation on your external mixer. When the playback

volume controls are set to 0dB and the input signal approaches the maximum pre-

clipping level, you can achieve the full 24-bit dynamic range of the system.

Clock and digital mode settings

The area within the yellow outline on the upper right lets you select your sync

source and digital mode. If a given clock is detected, the indicator next to the

clock button will turn green. You will only be allowed to select clocks that have

been detected. In order for a digital clock to be detected the console must be set to

the appropriate digital mode. Also, you may only select the digital mode if there

aren’t any applications actively playing or recording.

Note: Sample rates above 48kHz will not be available while ADAT mode is

selected. This is because ADAT does not support sample rates higher than

48kHz.

WDM console – all products

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 109 110

No comments

Echo Audio MiaMIDI Owner's Manual Page 39