Echo Audio MiaMIDI Owner's Manual download pdf (Page 28)

Audio Connections – MiaMIDI

MIDI-S/PDIF Breakout Cable

To connect MIDI or S/PDIF signals to MiaMIDI, you will need to first

connect the breakout cable. The breakout cable looks like this:

MIDI and S/PDIF inputs are on the left side, just under the label “IN”.

Outputs are, obviously, on the right.

To use the breakout cable, connect the 7-pin DIN connector at the other end

of the breakout cable to the connector labeled “MIDI S/PDIF” at the bottom

of the PCI card bracket.

The S/PDIF connectors are used to transmit digital audio data via an

electrical signal. S/PDIF data can use the full 24-bit sample width used

internally on MiaMIDI.

When connecting devices to the S/PDIF jacks on MiaMIDI, the use of

standard analog RCA audio cables is not recommended. For reliable S/PDIF

operation, 75ohm coaxial (RG59) video cables are recommended.

The MIDI ports can be used for receiving MIDI time code (MTC), or

sending MIDI signals from your digital audio/MIDI sequencing software to

external sound modules, etc. MIDI cabling is highly standardized and

widely available.

Audio Connections – MiaMIDI

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 109 110

No comments

Echo Audio MiaMIDI Owner's Manual Page 28